Custom Countertop Problem

[emillerinc]

Let me see if anyone has had this problem...

1. Draw a standard 24" base cabinet

2. Draw a 1" deep, 24" wide base cabinet and attach it to the side of the previous one (I use this to do paneled ends on cabinets)

3. Draw a custom countertop at standard height that overhangs the two cabinets 1" on all sides.

4. Take a 3D view and look at the side where the 1" deep cabinet is.

The custom countertop snaps somewhere different than where it was drawn. When I go back to plan view it shows it snapped as well. It only snaps when I take any sort of camera view. I have tried putting it on it's own layer and locking it and also turning off auto-snap but it still changes the size of the top.

I use shallow cabinets to show paneled ends very often so this has been a problem. If I use a polyline solid it still snaps. The only thing I can do is use a soffit, but it's not very editable as far a shape.

Thanks,
Kevin