Results 1 to 15 of 19
Thread: Approximation Symbol
Hybrid View
-
01-18-2008, 06:38 AM #1Registered User Promoted
- Join Date
- Oct 2006
- Posts
- 209
Isn't there a setting in DEFAULTS that will have the system generate a 'tilde' when the measurement is less than a prescribed value?
I thought I saw that in there. It shows a 'tilde'. I'll go try it and come back.
Wait a secAlan Michaud
"Al"
Central Maine
-
01-18-2008, 06:55 AM #2Registered User Promoted
- Join Date
- Oct 2006
- Posts
- 209
Not sure this is what you wanted but Chief has this built in. If there is a measurement less than 1 siteenth of an inch you can set the Default Dimension controls to display a tilde before the numerics. A screen shot is below.
Alan Michaud
"Al"
Central Maine