Results 1 to 3 of 3
Thread: Cabinet resizing
-
01-03-2001, 09:44 PM #1Registered User Promoted
- Join Date
- Jan 2001
- Location
- Middleton, Nova Scotia, Canada
- Posts
- 4
Cabinet resizing
Greetings everyone,
I installed Ver7 and have been running it about 2 weeks, and now seem to have a problem with resizing cabinets & shelves.
I've gone into Plan defaults and clicked on resize enable, but still cannot resize cabinets with the mouse. I have to go into the cabinet spec dialog and type in a dim., and the odd times when I type in a width it automatically changes to 2047.
I'm at a loss as to what to do, anyone else have this problem, or am I over looking something.
Thanks, Kevin
Just discovered that I can change depth only, with the mouse. In 3d I can change width with mouse ok.
[This message has been edited by KEVINGARRETT (edited 04 January 2001).]
-
01-04-2001, 03:45 AM #2
Kevin,
Sorry you are having a problem. I am also sorry I cannot confirm that my two machines with Version 7 on them are not producing a similar difficulty with resizing cabinets.
Under "cabinet defaults" you might set the "increments" to 1 inch, I have found that that makes resizing cabinets in whatever view much easier.
------------------
David J. Potter
Chief Architect© Consultant, Beta Tester, Designer
1801 Wells Branch Parkway #2013
Austin, Texas 78728
dpotter1@austin.rr.com
512-251-3982
305-425-5794 FAX http://members.spree.com/djpotter
[This message has been edited by David Jefferson. Potter (edited 04 January 2001).]
-
01-04-2001, 09:35 AM #3Registered User Promoted
- Join Date
- Aug 1999
- Posts
- 6,414
this problem will happen if you set your cabinet default's minimum width to less than 1 inch as when you close the dbx it will set it to 0 instead of any fraction, reset this to a value over 1 and it should work okay if you need anything under 1 inch use the partitionas it can be set down to at least 1/16"