Batt hatch?

[Joe Carrick]

The problem with using a batt hatch with Chief walls is that the pattern origin is not tied to the wall, but to the drawing origin.
I can clearly see this when I move a wall in one inch increments with the cursor keys.

Bill, you are quite correct. That means that a very simple pattern has to be used - maybe something like what Bradley showed.

OTOH, as a fill for a wall layer it would be up to Chief Architect to adjust the origin of the pattern. This could be done in programming and really follows one of my requests to allow x/y offsets for fill patterns in general on a object by object basis.

Note: There has been some discussion of this problem and the need for a Linear Pattern Fill in the following thread http://www.chieftalk.com/showthread....ht=cross+hatch