Results 1 to 10 of 10
Thread: Polyline Ridge Cap
Threaded View
-
11-08-2008, 12:24 PM #4Registered User Promoted
- Join Date
- Mar 2006
- Location
- Ashland, OR
- Posts
- 1,386
George,
there is nothing complicated about these moldings as you can see below. they are simply drawn using the cross section cameras shown the plan view in the original post. They are drawn for the specific common and hip pitches that are used so they will vary; but they are certainly not hard to draw. I have exaggerated their height for emphasis when rendering.
Bryce,
Here they are in elevation. This would be even easier with tile as you would not need two moldings at the hip, and you would not need to miter the ends at the eaves. I would suggest just drawing the molding along the ridge lines, and then using the transform replicate tool to shift them over half the width of the tile measured on the diagonal.Last edited by billemery; 11-09-2008 at 09:34 AM.