Stairwell

[DougM]

In taking an overall view of the inside of this room, I notice my stairs to the basement are missing, I have the well opening labeled as OPEN BELOW. The stairs show in plan view (1st floor) Any Ideas that will get them to show? As you can see, its a bit drafty....I've noticed this a few times in other plans but never paid any mind to it , only cause at the time it did'nt matter. Now it does. Anyway , any suggestion welcome.
See Attached.
Doug

[Allen42acj]

Doug
Use the cross section slider tool,cut off the top of the house.

[DougM]

Thanks much Al.. That worked great.....Any Idea why it doesn't show when the "Render Floor Overview" Tool is used? Just curious.

Doug

[roraback]

Doug, It did not work because the render floor overview tool is only designed to show what is contained on a particular floor. The stairway that you are referring to is on the lower floor. Anything below the floor platform is considered to be on the lower floor. Hope this clears it up for you, Bob

[DougM]

Thanks Bob, Yes it does.

Doug

[Allen42acj]

My render view picks up the basement stairs..

[DougM]

Try pulling the stairs toward you more ...out from under the raised floor, See if it works for you then. Mine doesn't work...hummmm

Doug

[icy]

Allen: using render camera view
Doug: using render floor overview
Hope this clears the confusion.

Peter

[DougM]

Yes, it does.......mine is the same then. I still think ya should be able to see the stairs with Render Overview. Thanks Peter

Doug

[Allen42acj]

Peter
No,I get the camera names all screwed up.
No biggie