Results 1 to 6 of 6
Threaded View
-
12-13-2012, 08:21 PM #1Registered User
- Join Date
- Dec 2012
- Posts
- 2
Using the same material at different pattern angle?
Hi,
I am new to chief and currently trying to design a bathroom. Thanks to this site, I was able to figure out how to do some of the design. I am using polyline solid to isolate different sections of the walls to draw different tile patterns.
What I can't figure out is how to use the same material but rotated at 90 degrees. What I have is 12x24 tile, which in some sections is applied horizontally and vertically at others. I can do it by defining 2 separate materials (eg 12x24 and 24x12 (or 12x24 angled at 90)), but then on the list of materials they are reported as 2 different materials.
I also tried the Adjust Material Definition option, but if I change the angle inside one polyline solid, it changes it everywhere else too.
How could I make it work?
Thanks in advance!