Line end caps

[Keith_K]

Hello,

I am new to Chief Architect, and have tried hard to learn as much about the program prior to posting any questions in these forums. However, I have been disappointed in the way line ends are handled in CA, and after searching through past posts it doesn't seem that the program has a good solution to this problem.

Apparently, if I show "line weights" then my "end cap" size is ignored, and I can end up with spaces at ends of dashed lines. I don't like this look at all. I thought I had found a work around by using arrows at both ends that appear as a simple line instead of an arrow. There is such an arrowhead in the list. Unfortunately, no arrow appears, and neither does the anticipated 6" long line I expected for the 6" flat arrowhead that I setup.

If I choose any of the other arrowheads I can get a 6" long arrow, but I suppose the flat one is really nothing at all. Is there a way to create a new arrowhead to do what I want? Or, does anyone have any other suggestions?

Keith