Results 1 to 4 of 4
Thread: Cathedral Ceiling Problems
Threaded View
-
03-05-2003, 09:18 AM #1
Cathedral Ceiling Problems
I have a two level house. The upper level does not cover all of the first floor. In the area that is not covered, the ceiling is a cathedral design. When preparing the drawings the camera view showed all areas were correct. The Cathedral ceiling in the room was fine. The rest of the lower level was at 97" as desired.
However, as I prepared the interior steps and doorways etc., the top of the cathedral room walls are now the siding that is on the outside of the upper level. No matter what I try, it will not change.
I have come too far to redraw now. I have tried to redraw the same general configuration in another plan as a test bed and it is just fine.
If anyone knows what is causing this condition, I would appreciate some help.
Paul