Results 1 to 6 of 6
Thread: scrap lines
Hybrid View
-
02-16-2005, 08:29 PM #1
Registered User Promoted
- Join Date
- Oct 2004
- Location
- Australia
- Posts
- 13
scrap lines
I am verly new at using this Forum and have lots of questions but one at a time. When I get up an elevation I have scrap lines showing in different places, some showing from the other side of the house at ground level, some where lower and upper storey walls meet and around the fascia. How do I get rid of these?
-
02-16-2005, 08:54 PM #2
Member
- Join Date
- Oct 2003
- Location
- Carmel IN
- Posts
- 61
try
in the Tool-Bar , click the refresh icon
or do an F-5 keystrokegrp
-
02-16-2005, 11:00 PM #3
General Contractor
- Join Date
- Aug 2000
- Location
- Northern California
- Posts
- 475
Build framing, floor/walls/and roof. That will clean up most of it. Then, you will need to use "edit layout" function ( after you send the elevation to layout ) to do a final clean up.
Jere Johnson
Version X3 & X4 & X5 latest
Electra Glide Standard
-
02-17-2005, 12:04 AM #4
Registered User Promoted
- Join Date
- Oct 2004
- Location
- Australia
- Posts
- 13
Thanks guys for your replies, both ideas worked to a certain extent but not all of the lines disappeared.
I have skillion ceiling inside and seems to have something too do with some of the lines at the top part of the wall.
As yet I have not done much in the way of foundations, do you need to do that to do the elevations.
At the moment I just drag the walls down to ground level.
-
02-18-2005, 02:36 PM #5
General Contractor
- Join Date
- Aug 2000
- Location
- Northern California
- Posts
- 475
I'm not sure what you mean by "skillion ceiling", probably that you have a lot of extra lines to clean up (?) but build your foundation and frame floor walls ceilings and roof to get a fairly clean elevation. But there is always a little clean up to do in layout. Wait untill you are sure you have the elevation you want because if you re-open an elevation, change it and then up-date it to layout, you will have to do your clean up again.
Jere Johnson
Version X3 & X4 & X5 latest
Electra Glide Standard
-
02-19-2005, 12:38 AM #6
Registered User Promoted
- Join Date
- Oct 2004
- Location
- Australia
- Posts
- 13
Thanks Jere,
I think I need to look at the training videos on building frames and floors etc., up to date I have not done much of that, I have been concertrating on getting the floor plans and sites right.