Layout Problems

[Dave]

I am having difficulty in printing layout files. I have a master layout format sheet I use. It prints fine without any plans/elevations. Whenever I send an elevation or plan to the sheet and try to print, it crashes and gives an error message, see below. I am using 6.0, but had the same problem with ver 97. I have stayed updated with the patches.

I both imported the layout sheet from 97 and created a new one in 6.0. The file is imported from 97.

Has any one else had similar problems and do you know how to fix it. thanks

Below is the error message I received:

CHIEF60X-32 caused an invalid page fault in
module CHIEF60X-32.EXE at 015f:0063b06c.
Registers:
EAX=74726f50 CS=015f EIP=0063b06c EFLGS=00010246
EBX=00b2fb58 SS=0167 ESP=00b2d690 EBP=00b2d9d8
ECX=00b2d734 DS=0167 ESI=000000ab FS=478f
EDX=00b2d734 ES=0167 EDI=00b2fb0c GS=0000
Bytes at CS:EIP:
ff 50 20 8b 0d 84 23 82 00 8b 95 dc fc ff ff 89
Stack dump:
0155e3c0 00000000 00000000 00000001 6f6e6143 7542206e 656c6262 74650000 2d4a4220 00000000 bff00000 00000000 bff00000 00003a31 00000000 65696843

[fitz]

Hi Dave, I have had the problem, usually when I had a lot of CAD drawing on the Layout Sheet. It would crash, and usually print OK on a reboot. Sometimes if I printed another sheet first,then the "crasher" it would be OK.
I think your problem is RAM. I upgraded to 128K and have never had a problem since. How much of this 'juice' do you have?
Mike Hall
San Diego