Stone Material Hanging Up on Raytrace (X6)

[jpremodeler]

I have tried several Coronado and Cultured Stone options, but when I raytrace with them, photon shooting freezes at 91%. If I switch to a "quick" set up, It works. Any thoughts??

[Chiefer]

It's good here.

[Curtis Johnson]

I downloaded your file and for some reason, I didn't get all the stone textures when I opened the file in X6. I see Jintu seemed to get them all. The only stone textures I can see in the full overview is on the short section of stone on the left side wall and the short section of wall on the right side of the main entry alcove. All the rest of the stone, including the walkway, is missing. Go figure?!

When I did RT the model as is, the two sections with stone textures did RT just fine with no hangup.

[Curtis Johnson]

Looks like I don't have the Coronado Stone library downloaded into Chief. It looks like you must have painted over the lower pony wall material. When I click on the wall > wall type > define and look at the outer material, it is Idaho_Drystack_Buff, not the Coronado stone texture you must have changed it to. Apparently your compressed plan file was made without backing up the entire plan. I am downloading the Coronado Stone library into Chief right now and will try again when that is done to see if the missing texture(s) show up.