Room Specification dialog Disappearing

[DougM]

X6...after selecting room or room elevation>opening it's specifications, selecting materials or wall coverings, the entire specs screen drops out of site, if I click anywhere outside working area, it reappears...this is getting really annoying. Is there some sort of new setting for this, timed or otherwise...or is it a bug?

Thanks in advance,
Doug

[victor rasilla]

I've noticed similar issues with disappearing dbx´s

[DougM]

I've noticed similar issues with disappearing dbx´s

Yeah, it's driving me up a wall. I have to hold my mouse button down (or pen if I'm using my tablet) on top of the DBK for it to stay visible, then try and click on my selection before it disappears again. Guess it's time for a tech call today.

[dshall]

I have not had any problems with the room dvx until today. What is happening today is, if I am on level zero, mono slab, and I select a "room", the dvx opens up, and 1.5 seconds later it relocates itself. This does not happen on any other levels, only on level zero.

[DougM]

I have not had any problems with the room dvx until today. What is happening today is, if I am on level zero, mono slab, and I select a "room", the dvx opens up, and 1.5 seconds later it relocates itself. This does not happen on any other levels, only on level zero.

Yup, basement level, doing a bathroom and while using material regions...about 5 seconds into selecting material such as tile, the dbx disappears. Also another bug in it...if you lessen thickness of any of the selected materials, it (the new material)will bury itself within the wall surface and no way to change it other than step backwards...I reported the issue and they (SSA) put it on the wish list. In the mean time...

[dshall]

I have not had any problems with the room dvx until today. What is happening today is, if I am on level zero, mono slab, and I select a "room", the dvx opens up, and 1.5 seconds later it relocates itself. This does not happen on any other levels, only on level zero.

I should test this with another plan. The one I am experiencing this issue with has been giving me a few other INCONSISTENT problems, i.e. takes forever (3-4 minutes) to change a layer set for an elevation…… or any kind of messing around with a back clip cross section. Giving me fits earlier (unworkable), and then suddenly it cleared up and all was well.

[DougM]

Let me know if you find anything.