Room Specification dialog Disappearing

[dshall]

I have not had any problems with the room dvx until today. What is happening today is, if I am on level zero, mono slab, and I select a "room", the dvx opens up, and 1.5 seconds later it relocates itself. This does not happen on any other levels, only on level zero.

I should test this with another plan. The one I am experiencing this issue with has been giving me a few other INCONSISTENT problems, i.e. takes forever (3-4 minutes) to change a layer set for an elevation…… or any kind of messing around with a back clip cross section. Giving me fits earlier (unworkable), and then suddenly it cleared up and all was well.