Pocket doors will not display hardware - X6

[Gene Davis]

Got a solution. Install the flush pull in the door in Sketchup, and then save and import the .skp symbol, with its pull already there.

Put your pull on the L side of the door to make this work right, as shown in the overhead view of the .skp model.

Hey, Chief, fix this, will ya? Pocket doors need pulls, and while you are fixing it, add a couple of different kinds. One, the kind that wraps the edge of the slab, another, one that installs flush into the middle of the face of the stile. We know you cannot recess them flush into the door, but you can surely fake something.

The close view is FYI.