X6 Wall elevation missing right side of walls when sending to layout

[charlesu]

This is happening in all my wall elevations.
When using the wall elevation tool the elevation looks fine until sent to layout.
In the layout the right walls do not show.
I know the simple fix is to draw the cad line, but I would rather not.

Thanks in advance.....

[Curtis Johnson]

Charles:

I have seen that as well. I haven't reported it ... just leave as is as long as I am able to get all my dimensions in as needed. Sometimes I have run into cabinets that my dimensions won't snap to or pick up. Not all ... just a few ... but end up putting in a small CAD line to dimension to.

[charlesu]

Thanks Curt, good to know its not just me!

[perryh]

I usually just put a thick cad line around it mainly for looks.