Results 1 to 4 of 4
-
01-26-2014, 01:05 PM #1
X6 Wall elevation missing right side of walls when sending to layout
This is happening in all my wall elevations.
When using the wall elevation tool the elevation looks fine until sent to layout.
In the layout the right walls do not show.
I know the simple fix is to draw the cad line, but I would rather not.
Thanks in advance.....Charles Uyehara AIA
Architect & Architectural Photographer
Design Partners Inc.
Honolulu, Hawaii
www.designpartnersinc.com
-
01-26-2014, 01:58 PM #2
Charles:
I have seen that as well. I haven't reported it ... just leave as is as long as I am able to get all my dimensions in as needed. Sometimes I have run into cabinets that my dimensions won't snap to or pick up. Not all ... just a few ... but end up putting in a small CAD line to dimension to.Curt Johnson
X5
Puget Systems Custom Computer, Win 7 Pro 64-bit SP1, 3.3Ghz Intel Core i5 2500K Quad, 8 GB Kingston DDR3-1333 Ram, Intel X25-M 80 GB SSD App Drive, WD 500 GB Caviar Blue SATA 6 Gb/s Data Drive, EVGA GeForce GTX 550 Ti 1024MB VC, Antec 650W PS, Asus p8P67 Pro REV 3.0 Motherboard
-
01-27-2014, 12:49 PM #3
Thanks Curt, good to know its not just me!
Charles Uyehara AIA
Architect & Architectural Photographer
Design Partners Inc.
Honolulu, Hawaii
www.designpartnersinc.com
-
01-27-2014, 01:29 PM #4
I usually just put a thick cad line around it mainly for looks.
Perry
P.H. DESIGNS L.L.C.
Eastvale Calif.
Alienware, liquid cooled
Ver 10-"X6 x64 SSA
WIN 8.1 PRO 64 bit
Nvidia GTX780 3GB.
i7 920 2.67-- 12 GB Ram
40" led monitor