Just "Another" Dimension Snap Issue

[Bradley Boltz]

Glenn, my post begins: "I'm using x5........"

Not worth posting as it happens on occasion as corroborated by Larry and when I does, it's impossible to get the dimension to locate (in this case the fascia) and finding nothing to snap to, the dim snaps to something way the heck off of the drawing. I've actually sent this in to Chief tech support on one occasion and never receive a solution. I get around it by placing a vertical cad line & dimensioning to it.

Since the x-versions, I think Chief takes too long to refresh when redrawing the screens when you add or modify a cad object. At some point v-8?, Chief gave cad lines "selection preference" when you were in "Cad mode". This was back when a dimension arrow automatically had a "joint" without having to use (didn't have he ability to add more than one joint or hinge either) the break line tool (more time consuming) and you could place and edit text with arrows a lot quicker. Back then, the text leader arrows didn't go all wanky when you drew a cad line or moved one that currently causes text leader arrows to snap to something you later draw and then move. I believe v9 before the unnecessary 9.5 mid-season version upgrade (to Kiss Home and Gardens Butt for obvious monitary reasons) had the fastest and best editing of text with leader arrows as well as the cad behavior and left and right click selecton of objects (especially cad objects)was better than now.

Finally, why is it so difficult to select a cad polyline once it's been converted into a cad polyline solid? You can't left click select when in polyline mode and you can't select it with the fence tool while the polyline box tool is active either. The only way you can select it is with a left mouse click which is virtually impossible if you are using a polyline solid as a beam with other cad overlaid. The only way to select it is by using the "next" button in many cases in a complex plan. One would think that Chief would give you selection priority with a "polyline solid" selection icon of some sort. It fails their otherwise good selection logic of if you've selected the "draw wall" tool, you can expect the selection (left button) to give priority to snapping to and selecting a wall even if there's a cad box overlaying it. Nuff Said.-BB