Property lines via bearings

[Ben Palmer]

If i am given this information for a curve, how do I input it into Chief using the New Arc input tool?
Length: 112.59'
Radius: 531.50'
Chord: 112.59'
Tangent: 56.51'
Delta: 12degrees 08minutes 14seconds

See attached pic...North is up. (the above info is for C83)

[Nicinus]

If i am given this information for a curve, how do I input it into Chief using the New Arc input tool?
Length: 112.59'
Radius: 531.50'
Chord: 112.59'
Tangent: 56.51'
Delta: 12degrees 08minutes 14seconds

See attached pic...North is up. (the above info is for C83)

I think you gave the wrong info on either chord or length but based on what I've learned so far, since you have chord length I would probably enter the curve segment as a line to create the closed polyline and then convert that segment to a curve by entering the data in the dialog and locking chord?