X6 Beta - lines unselectable after trim

[gawdzira]

I am having an issue with trimmed lines. I opened a new plan and did the experiment shown in the image.

1. Draw a line (this one started at the left side
2. Draw a polyline rectangle as shown
3. Select the rectangle and trim in the center.
4. The right side is unselectable by clicking on it but selectable by marquee selection.
5. The left side is acting correctly.

[moak]

I just tried this and have the same result.

[William H Lynch]

'Refresh Display' will make it selectable.... until the bug is fixed...

[Joe Carrick]

Note: "F5" is shortcut for "Refresh Display"

[Doug Park]

Interestingly, this is a bug in X5 also.

[dshall]

I too have noticed this behavior whereas I cannot select something and I end up selecting via marquee. Do not remember the exact situation, but will keep an eye out for this and report it next time I see it.

[lgswe]

I always thought it worked that way. (hitting F5 to make it selectable after trimming out of the middle)