A Commercial Bathroom Stall Partition "How To" using Railings

[dshall]

..................... Lastly in the rail tab make the rail square and set for auto width and set the height to whatever you want probably as non-existent as you need it to be.
..........................

Aaron, I did not understand this step, would you mind 'spaining what you are doing here? I do not see the rail in your picture.

[amddrafting]

I do not see the rail in your picture.

Exactly,

Basically do what you gotta do to get rid of the rail since most partitions don't have them. By setting the auto width it will make the rail as wide as the wall, then just set the height where you want it to be (1/16") so it basically disappears.

This won't work of all partition types obviously, but it's a great way to get it done quickly in 2D.

Also forgot to mention to be sure to suppress the door casing if it shows up. Mine didn't but it could on yours. With the right hinges and hardware you can really get this too look pretty realistic.

[amddrafting]

Oh and Mr. Hall. I think this could be a great video "how to." If you want to tackle it be my guest.

[dshall]

Oh and Mr. Hall. I think this could be a great video "how to." If you want to tackle it be my guest.

It is not Mr. Hall to you, it is Drop-a-Shot Hall, anyway, I am one step ahead of you, video is now cooking. By the way, I do not think you have the top rail turned on in your picture. There is something else that handles that situation, explained in the vid. Nice tip Aaron, thanks a ton.

vid link here

http://www.chieftalk.com/showthread....989#post468989