A Commercial Bathroom Stall Partition "How To" using Railings

[amddrafting]

X5 - But I'm sure you could achieve the same or close results in version 10.

[BA Grant]

It seems i can't raise the bottom of the partition to 12" to 16" with this version. Can it be done in x4.

[BA Grant]

see

[amddrafting]

Honestly I'm not that concerned about the overall look of them unless I have to show them in an elevation view. My main problem has always been editing the stalls to meet code and to have doors in them so that everything can be easily edited and adjusted to meet the sizes I need.

So what you're doing in plan view should work just fine in previous CA versions.