Results 1 to 3 of 3
Thread: CAD Bearing
Threaded View
-
01-05-2013, 03:39 PM #2
Matt,
Draw a line.
Open it's dbx.
Down the bottom, click Num Style...
Select Azimuth Bearing.
Without a North Pointer in the plan, zero degrees is straight up.
Once you have a North Pointer in the plan, zero degrees is same a north pointer.
Note that this setting only applies to the values in the dbx, not the actual line information display.
If you want your line to display the same value, go Defaults...CAD...General CAD and change to Azimuth Bearing.Last edited by Glenn Woodward; 01-05-2013 at 05:00 PM.
Glenn
Chief X5
www.glennwoodward.com.au
Windows 7 - Home Premium
Intel i7-920
Gigabyte GA-EX58-UD3R
6 Gb DDR3 1600MHz
EVGA GTX285 1GbDDR3
1TB Sata HD