Angular Dimensions

[Payne]

I seem to have a bit of a hiccup with my angular dimensions.

Example:
I draw a detail at 1:10 scale, send it to layout.
Go back to my plan, change my active annotation set to a 1:100 scale.
Go to my layout page and my angular dims are all HUGE, yet all the other dims are the same.

They seem to change with whatever the set is that I'm using at the time, even if its not in the same CAD detail section (I have a different one set up for each one I use).

I'm not sure if I described that in a way that is understandable...

But any help would be handy.