Marque Move - What doesn't move ?

[Joe Carrick]

I thought you could adjust the fill in a room by room basis if needed.

Do you see anyplace in the dbx to adjust the x or y offsets? I added another example that shows how any single Fill Pattern always lines up regardless of the boundary.

[dshall]

Do you see anyplace in the dbx to adjust the x or y offsets? I added another example that shows how any single Fill Pattern always lines up regardless of the boundary.

Will check out in AM, I am flying blind right now.

[Joe Carrick]

Will check out in AM, I am flying blind right now.

Hey Scott,

Did you ever get around to investigating this?

[dshall]

I could not figure it out.

[Dave Pitman]

I added another example that shows how any single Fill Pattern always lines up regardless of the boundary.

Nice example.
I tried it using the room fill tab in all but the room on the right where I used a room polyline. The fill still lines up.

_