Can you identify this ?

[Ron Ravenscroft]

OK Guys - here's the answer. The Pic below shows a couple of the Millwork Symbols that I created and stored in my library.

1. A Vertical 2x4x12" Aluminum Mullion
2. A 60" wide x96" tall Panel with top, bottom & 18" high Rails. The Panel has a Stretch Plane at z=36"

I drew a wall 9' tall and edited it in the Wall dbx to be a Railing.

Panel, Post to Beam. I set the Newel and Railing Heights to be 80" and used the Millwork Mullion for the Newels and the Millwork Panel as the Panel. Then I inserted a door (Glass with Hardware from the Library) and added a mullion as the header over the opening. I changed the Railing Beam to Beige Stucco and set its size to 8"x29".

I made the Newel Spacing 39" so that the panels would be about 36" wide (depends on the wall length)

Joe,

how about sharing a plan with all of us.

Ron