Results 1 to 1 of 1
Thread: wall surfaces
-
03-18-2000, 04:34 PM #1
Fire Chief 58
- Join Date
- Aug 1999
- Location
- JERMYN, PA. USA
- Posts
- 1,060
wall surfaces
On one of my plans when I do a full view camera shot I keep getting error message #436 wall surface production error I looked it up in the error file but explanation is vage. Could anyone tell me what this might be.
The plan is a bilevel and when I draw the steps from the entry level to the first floor level my steps block off part of a closet wall at top of steps I read manual but it does not say if you can line break steps so railings run into wall and then have steps go along side of closet wall. Steps does not show line break.
Thank You to anyone that might be able to help.
------------------
Ray
RRGC@AOL.COM
Reply With Quote
