Results 1 to 8 of 8
Hybrid View
-
03-27-2012, 12:50 PM #1
This is commonly caused by poor wall connections (I know you know this) but it is well to state it again because it is the main reason for no floor and ceiling.
Make sure if you customised your walls that the "Radio Button" is next to the main structural layer as well as if this is missplaced it can cause lots of unwanted wall and dimensional behaviors.
Just zoom in and fix (redraw) any corners that do not look "right" (even, smooth, correct) and make sure your walls are defined properly. Zooming in to wall junctions is a key action.
DJP
David Jefferson Potter
Chief Architect ® Trainer, Beta Tester, Draftsman, Author of "Basic Manual Roof Editing" and Problem Solver
Win7 Ultimate x64 & XP Pro x32, 500 Gb Samsung SSD
AMD Phenom II X6 1090T, 8Gb DDR3 RAM, PNY 760 GTX
Chief 7-X6, Home Designer versions 7-2014
3101 Shoreline Drive #2118, Austin, Texas 78728-4446
Office Phone:512-518-3161
Main E mail: david@djpdesigns.net
Web Site:http://djpdesigns.net
My You Tube Channel
Help is just an e mail or call away!