Fascia Molding Corners

[Joe Carrick]

Aaron,

Ideally, this would be a part of the Roof dbx (Framing Tab) as a "Shadow Board" similar to the Gable & Eave Fascias. But instead of (or perhaps in addition to) specifying thickness & width we would be able to specify 2D Molding Profile(s) and/or 3D Molding Symbols. In any event, this item should be applied directly to the Fascias and should miter at all corners. If Square Cut or Plumb Cut Eaves, this Trim has to be applied tight against the Fascias!!