Results 1 to 15 of 95
Thread: Design vs. engineering question
Hybrid View
-
04-04-2011, 01:54 AM #1
Are you permitted to stamp something (assuming its drawn correctly) if you didn't draw it up? Where is that line drawn legally?
Michael:
they don't have to draw it, but it does have to be drawn under their direct supervision.
scenario 1:
a drafter (employee or independent) sitting in the same office
given instructions on what to draw
hould be fine unless it could be proven that their was no
supervision
scenario 2:
a drafter (employee or independent) working at home via the internet
given instructions on what to draw
very questionable unless there is a proven record of supervision
with one engineer we worked with who was near retirement (old school)
he would create the hand drawing and then we would re-do it in chief
he would then review it and sign it
this allowed us to show the same cad detail from the various points of view
(left.ight,front,back,top,bottom)
he would do one drawing and we could have 6 drawings in the permit set
or we could do cross-sections etc
I kept the original drawing(s) and all the emails
at the end he printed and signed the final PDF's (sent vie email)
and we then added his pages to our pages (sent via courier)
as needed, we would annotate our pages giving a callout to his pages
LewLew Buttery
Castle Golden Design - "We make dreams visible"
Lockport, NY
716-434-5051
www.castlegoldendesign.com
lbuttery at castlegoldendesign.com
CHIEF X5 (started with v9.5)