Results 1 to 12 of 12
Threaded View
-
03-10-2011, 01:02 PM #4Registered User Promoted
- Join Date
- May 2006
- Location
- Orangeville, Pa.
- Posts
- 1,227
I found some strange things happening when I lowered the door unit. Looking at the door in a cross section it shows the sill approx. 1/8" higher than my 3/4" finished wood floor before I did any lowering. I lowered the door 1/4" and the door dropped 1/4" below the subfloor and I lost the sill altogether. When that happened I thought I would try raising it to see what would happen. I raised the door 1/16" above zero and looking at the cross section the door raised 1/16" above the subfloor. It kept the sill this time on the outside but CA put an apron under the sill. WHAT GIVES CHIEF?!!!!! Does this happen for anyone else? This is happening for a out-swing door. I'll have to "research" a little more and see if CA behaves the same for a in-swing door. Would this be a "bug" or has CA always worked this way?
Larry Sweeney
Designer/Builder/Restorations/Period Cabinetmaker since 1972
Chief X5, AutoCad 2010
Windows 7 Pro
Asus P8P67 Pro
Intel Core i7 2600k
8 GB DDR# 1600mhz
GTX 670