Results 1 to 4 of 4
Thread: Walls will not align in X2
Hybrid View
-
12-13-2010, 05:38 AM #1
I agree with Lew on this. I don't have any snap turned on unless I need it. If you don't see your snaps in a toolbar, right click on a top toolbar and select "extended toolbar configuration". Now you'll see them and other helpful tools. When drawing walls, in general, always be sure you do have the On angle snap turned on so that you will draw with the allowed angles only. Be sure the behavior setting is set to default. If you're not drawing based on snap grids, then turn off snap grids too. Be sure the main layer for the walls are set to outside of framing (it should be like that by default though).
If nun of this helps, feel free to call me if you like.Tommy Blair
Houston, TX.
(713) 467-0579
tblair55@sbcglobal.net
Avid Chief User V8-X5
Lead Houston User's Group
HP Dv7t Quad Edition Laptop
W7 Home Premium, 64-Bit
2nd Gen. Intel Quad Core i7-2720QM 2.2 GHz (turbo boost to 3.3 GHz)
1GB Radeon HD 6770M GDDR5
8GB DDR3 System Memory, 640GB 7200rpm Hard Drive
(2) 2.0 ports, (2) 3.0 ports
17.3" Monitor (1600x900)