Results 1 to 4 of 4
Threaded View
-
11-30-2010, 01:38 PM #2
Tom,
You have to "convert" the contour lines to Chief elevation lines & assign an elevation to each line. If your given contour line elevations from the dwg are relative to sea-level & you have a known sea-level elevation for your house (or can figure it out approx), it's pretty straight-forward.
The terrain tools are very good, but there are "bumps in the road" to watch out for. If you know where those "bumps" are,..............
If you're a current SSA member, there are very good tutorials on Chief's website.
Email me privately, & I'll be glad to help you out. I just did a session yesterday on this.
Jim
ebdesign@eastbaydesign.netThanks, Jim
www.eastbaydesign.net
East Bay Design, Inc
231.331.6102