Lower/Raise

[lbuttery]

Jorge:

try using select same and load same per floor starting with the lowest floor
to move the house to the desired lower height

the problem is each time you add a room or lose room definition chief will revert to the default of floor height 0
for that room

this applies for any of the multiple houses in the plan

it would be nice if chief wouldn't do this or at least warn us if it needs to change a floor height already set

this is a case where having floor locks would be desirable


Lew

[Jorge Araya]

Yes, thank you...!

What if your houses are multilevel houses? say 3 floors each?
Will you have to do floor by floor, room by room, and lastly the roof?

This will certainly be a big setback...

[lbuttery]

Jorge:

try the select same/load same per floor, starting with the lowest floor

It may be doable, but I doubt if it's "easy"

again it's subject to chief reverting to the defaults, whenever chief finds the need to do so


bottom line, your probably better off with a separate plan for each house and then convert them to symbols and place them in a master site plan

Lew