Results 1 to 3 of 3
Thread: Questions using the Block
-
02-01-2010, 06:47 AM #1Registered User Promoted
- Join Date
- Jan 2010
- Posts
- 28
Questions using the Block
I am doing two single occupant ADA toilet rooms. I inserted a block of WC, grab bars, and roll toilet paper holder in each room. All of the camera views in one room show everything is intact. In the other room, the baseboard is not showing up in any camera view within the area of the block. When I explode the block, the baseboard returns and all views are fine.
Why was this happening in one room but not in the other?
Should my groupings be left in block in the plan to stay intact just incase I do some revisions to the overall floor plan?
-
02-01-2010, 07:20 AM #2
which version of chief, many times it matters ???
check your room definitions between the two rooms to see if there
are any differences
maybe use the select same and load same tools to be sure the rooms are the same
if the problem persists you may want to sent it to tech support if you have X2
LewLew Buttery
Castle Golden Design - "We make dreams visible"
Lockport, NY
716-434-5051
www.castlegoldendesign.com
lbuttery at castlegoldendesign.com
CHIEF X5 (started with v9.5)
-
02-01-2010, 11:52 AM #3Registered User Promoted
- Join Date
- Jan 2010
- Posts
- 28
I have X2. I did check the room definitions and everything looked the same. I'll check it again.