Elevation Views

[carls]

I placed my four elevations on a layout page.
I then proceeded to dimension the elevation to get roof height.
Once on the layout I could not get the end to end to number format to feet and inches. Clicking on the individual cameras on the floor plan I could do the end to end and get the right number format. Once I send the auto elevations to a layout should I not be able to end to end dim and change the number format?


Hope this is clear...

[dshall]

If I understand, you are trying to dimension your elevations in layout, DON'T, dimension the elevations in plan.

[Tommy Blair]

Carl, are you dimensioning it in the elevation camera? It should update if you told it to. This is how I do it and never had a problem. Oh yea, If you don't see any dimensions in the viewport, then you probably have the dimension layer turned off. Select the viewport and be sure the layer is turned on.