Results 1 to 15 of 27
Thread: Score lines in stucco or eifs
Hybrid View
-
01-11-2010, 05:07 AM #1
Start with a newly created wall with all layer except your finished layer of ELF. Create a grid pattern in elevation view for all your joints, convert those lines to "V" grove (molding you created)to represent your joints. Prior to this offset all your lines that will become your expansion joints a given amount in both directions to be used for snap points. (distance depends on your joint profile). Put these lines on a separate layer. Couple of ways to do the next step, either clean up all the intersection and convert the newly created boxes to solids 1/8" thick or whatever your finished thickness is. Or using the lines offset as guide lines to drag solids/slabs/soffits whatever method you prefer, to fit each shape. Set your thickness and material accordingly, If they are well planned and layed out evenly, you should be able to copy quite quickly.
For windows and doors you'll have to use holes in solids. Or plan around the windows and doors.
See example , just a quickly but I think you'll get the idea. BTW, I didn't create a new wall, that's why there are 2 layers of stucco. Elininate the finished surface on your wall. The inserts will be your finish,Last edited by DougM; 01-11-2010 at 05:10 AM.
Doug Michel
General Contractor
Design & Build, New Jersey
Windows 7... 64 Bit,
X6 Build 16.1.1.9 X64 w/SSA
X5 Build 15.2.1.3 X64 w/SSA
X4 Build 14.3.2.2 X64 w/SSA
X3 Build 13.4.2.7 w/SSA
X2 Build 12.6.0.25 w/SSA
X1,V10,V9
Sketch Up Pro 8
AutoCad 2014
Adobe CS6 Design Premium
A Pool Cue , a Harley, a Hammer & a Camera
Good Isn't Enough... When Better is Possible.