Wall measurements

[USS Sandhu]

Ok, newbie question here on Chief X2...

If you look at the attached picture, I've added a point-to-point measurement which shows 20' 6"... but Chief displays 20' 7". It's not counting the thickness of the drywall, right?

Can I set Chief to only display the actual interior dimension? It would certainly make things easier. Is there a setting somewhere that I've missed?

Thanks in advance,
- Sam

[USS Sandhu]

Good grief... as soon as I post this I find the setting.

Good ol' Murphy and his laws

[spark]

For the sake of others who are confused, you need to change your Temporary Dimension Defaults from Wall Dimension Layer to Wall Surface to get identical results here.