Results 1 to 15 of 17
Hybrid View
-
10-28-2009, 06:40 AM #1Registered User Promoted
- Join Date
- Feb 2005
- Location
- Connersville, Indiana
- Posts
- 445
Thanks Tommy, is that the printer page setup? Doug I have been changing layers in wall set so i can see them better in zooming in to 12 for walls and 6 for drywall. Is this where I should do it?
Last edited by dparsley; 10-28-2009 at 06:44 AM.
David P.
From Broderbund to x5
-
10-28-2009, 06:58 AM #2Allen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com
-
10-28-2009, 07:05 AM #3Registered User Promoted
- Join Date
- Feb 2005
- Location
- Connersville, Indiana
- Posts
- 445
Thanks Allen
David P.
From Broderbund to x5
-
10-28-2009, 07:10 AM #4
Thank you Allen. David, if you're bringing V10 plans forward to X2, you'll also have to change the lineweights in the 'layer options" from plan. These go hand in hand.
Tommy Blair
Houston, TX.
(713) 467-0579
tblair55@sbcglobal.net
Avid Chief User V8-X5
Lead Houston User's Group
HP Dv7t Quad Edition Laptop
W7 Home Premium, 64-Bit
2nd Gen. Intel Quad Core i7-2720QM 2.2 GHz (turbo boost to 3.3 GHz)
1GB Radeon HD 6770M GDDR5
8GB DDR3 System Memory, 640GB 7200rpm Hard Drive
(2) 2.0 ports, (2) 3.0 ports
17.3" Monitor (1600x900)
-
10-28-2009, 12:30 PM #5Registered User Promoted
- Join Date
- Feb 2005
- Location
- Connersville, Indiana
- Posts
- 445
Off subject, had older plan with no garage, added breezeway and attached garage, Is there a way to generate framing for new add on without messing up framing for exiting?
David P.
From Broderbund to x5