shed roof clerestory and ceiling height

[jimmypader]

Hello all

I'm new to the forum and chief having drawn in autoCAD. the two are quite different. I've attached plans and pics.

I was cruising along until I started fighting with ceiling heights. I got the rear wall to be higher than the front wall and the same for the front wall in the GR using roof planes and extending walls.

desired ceiling heights:::front utility section, entry, GR = 8'; GR, kitchen, hall, MBr = roof plane; MBa = subject of future post.


I looked for a beam tool (it'll need one) but can't find it. tried creating a second floor with open below but that messed the exterior wall. tried invisible walls to no avail. tried creating a second floor with open below but that messed the exterior wall. this is the best I got it looking outside with an exterior wall in the attic. I can even put windows in it. but the ceilings inside are all messed up

all help is greatly appreciated