Results 1 to 10 of 10
Thread: Open below not working
Threaded View
-
03-26-2009, 01:53 PM #1Registered User Promoted
- Join Date
- Jun 2002
- Location
- Arkansas
- Posts
- 97
Open below not working
I have this house that I have cathedral ceiling in two separate areas. I have not working on this drawing for few days. I opened the drawing and was going to show a friend what it looked like inside with the cathedral ceiling with open rafters. Bingo, I did not have the open ceiling. There was a ceiling about 8' high and I cannot get rid of it. It is the same way in both areas. It shows open below from above and no ceiling on the first floor. This is a total disaster. The last time I looked at it everything was okay.
Any thoughts would be greatly appreciated.
Thanks for your time and have a nice afternoon.
LaMar
BTW using X2 and have shut down my computer and restarted but nothing works.