Results 1 to 3 of 3
Thread: Metric Plans? I can't find 'em.
-
11-17-2002, 09:41 AM #1Registered User Promoted
- Join Date
- Nov 2002
- Location
- Edinburgh, Scotland, UK
- Posts
- 2
Metric Plans? I can't find 'em.
The subject really says it all. I have just started using this product i.e two hours ago and although I can find the dimension defualts and have checked metric (having unchecked all other boxes) I can't seem to find the Metric Plans window that the manual and help refer too.
Frankly, I'm going nuts!!
If anyone could help I would be eternally grateful and will happily stand anyone a pint ( not everything is metric over here) should they happen to find themselves in Edinburgh.
Cheers
-
11-17-2002, 10:04 AM #2Registered User Promoted
- Join Date
- Aug 1999
- Posts
- 6,414
go to file>close all, then again go to file>change units and check the metric button...once you have done this, Chief will stay in the metric mode until you chage it back or open a plan that was drawn in imperial...
-
11-17-2002, 10:10 AM #3Registered User Promoted
- Join Date
- Nov 2002
- Location
- Edinburgh, Scotland, UK
- Posts
- 2
Jobs a good 'un.
Cheers Tim