Results 1 to 7 of 7
Thread: Newel offset in elevation
-
12-08-2008, 07:37 AM #1
Registered User Promoted
- Join Date
- Sep 1999
- Location
- Montezuma
- Posts
- 5
Newel offset in elevation
Why does a newel or balluster show offset in elevation but in plan view you have it where it belongs? I know I've seen this problem before.
Dale
-
12-08-2008, 09:08 AM #2
Registered User Promoted
- Join Date
- Mar 2006
- Location
- Ashland, OR
- Posts
- 1,386
This problem as to do with the origin of the symbol. You may need to copy the newel or baluster to "my millwork" and change the origin.
-
12-08-2008, 10:24 AM #3
Registered User Promoted
- Join Date
- Sep 1999
- Location
- Montezuma
- Posts
- 5
Out of 8-newells used in this plan why would I have trouble with two?
Dale
-
12-08-2008, 10:37 AM #4
Registered User Promoted
- Join Date
- Mar 2006
- Location
- Ashland, OR
- Posts
- 1,386
Are you placing them automatically in the stair DBX? If you place them maually the origin can be off.
-
12-08-2008, 10:43 AM #5
Registered User Promoted
- Join Date
- Sep 1999
- Location
- Montezuma
- Posts
- 5
They are actually going on a manually made railing on a deck.
Dale
-
12-08-2008, 12:06 PM #6
Registered User Promoted
- Join Date
- Mar 2006
- Location
- Ashland, OR
- Posts
- 1,386
There have been some reports of a very inconsistant bug with the origin of columns and posts. It might be good to call support.
-
12-08-2008, 12:26 PM #7
Registered User Promoted
- Join Date
- Sep 1999
- Location
- Montezuma
- Posts
- 5
Thanks Bill, I will report it.
Dale
Reply With Quote
