Results 1 to 7 of 7
Thread: New Tool?
Hybrid View
-
11-11-2008, 07:20 AM #1Registered User Promoted
- Join Date
- Sep 2000
- Location
- Cape Cod Mass
- Posts
- 724
Originally Posted by Dermot Dempsey
Originally Posted by Dermot Dempsey
As for the line weights being sent to layout and cad details, this is very helpful. I personally send all elevation and cross section views to a cad detail and have found that using the layer painter accomplishes the same in short order. Now,,,,, having all those lines land on their original layers rather than Line layer and Pattern layer would really be an enormous time saver in both layout and cad detail. I realize if the layer set that created the layout view or cad detail is set up properly there shouldn’t be the need to do the above as long as the line weights in the 2D view of a layer set are the same required for the 3D view of the same layer set. I’m not too sure about that one yet!!!!!!!!
Ok,,, hold off on that tool (original post),,, LOL
Thanks again, Ray