Results 1 to 10 of 10
Thread: Polyline Ridge Cap
Threaded View
-
11-10-2008, 10:00 AM #9Registered User Promoted
- Join Date
- Jan 2006
- Location
- Bozeman, Montana
- Posts
- 471
I tried to make a molding symbol for a ridge cap.
what I did was in a new plan (plan view) drew a solid 4"x8"x1/4" thick, then in section views canted the solid as a shingle would be on a ridge. converted to a symbol.
in another plan drew a cad line, converted to a molding polyline and used this new ridge cap symbol. seems to work ok, did I do it properly?
tried to copy/reflect it with trans rep tool, but it came out facing wrong direction.
Ideas?