Results 1 to 7 of 7
Threaded View
-
11-08-2008, 07:36 AM #2Registered User Promoted
- Join Date
- Aug 1999
- Location
- Ridgway, Colorado, USA
- Posts
- 2,917
You can change the vertical angle of the 3D Molding Polyline in any 3D view. Try opening 3D views and then play with them a little.
Open the DBX for each and on the "Selected Line" tab you will see that:
For the molding polyline you have only x,y coordinates for the ends of the line then you have a height setting on the first (General) tab.
For the 3D molding polyline you have x,y & z coordinates for each end.Larry
Lawrence C. Kumpost, Architect
No matter how much you push the envelope, it'll still be
stationery.