Results 1 to 3 of 3
Thread: floor heights
Threaded View
-
11-06-2008, 12:20 PM #3
John:
Once the roof is created it is independent of the house.
Use the transform/replicate tool to raise or lower the roof planes
in the "Z" axis. Turn off all the layers except the roof planes and the selection is easier. There is a method in X1 to select them without turning layers off but I'm not quite clear on it yet.
If the roof is simple or auto-genned then just delete it and then re-gen it.
LewLew Buttery
Castle Golden Design - "We make dreams visible"
Lockport, NY
716-434-5051
www.castlegoldendesign.com
lbuttery at castlegoldendesign.com
CHIEF X5 (started with v9.5)