Results 1 to 5 of 5
Thread: closing a polyline?
Hybrid View
-
10-16-2008, 05:35 AM #1
If their not connected, go to each joint and click on them. Once you click on the open spot, it should connect.
Allen Brown
Indy Blueprints
Residential & Commercial Designs & Drafting Service
V8-X4, Specializing in Plan Completion, Problem solving, & Chief Architect Training.
Free Chief Architect Training Videos:
www.IndyBlueprints.com
Need help on a plan? Or 1 on 1 instruction? Email or call.
www.UBuildItIndy.com
-
10-16-2008, 07:04 AM #2Registered User Promoted
- Join Date
- Jul 2006
- Posts
- 12
Thanks for your replies, gentlemen. Glenn- your suggestion did the trick. When I clicked on the pline, all the closed joints were diamonds and the open joint was a square. I was then able to close the joint successfully.
Ben Liu
CADbuiltBen Liu
CADbuilt, Inc.
Moorpark, CA