finished side panels on cabinets

[Gene Davis]

OK, took the easy route. Set a basecab on the floor, then set a wallcab nearby.

Opened wallcab dbx for spec, set at 4" off floor, height of 30.5", width left at the 24 default. Set depth at 1/16". Went to fronts and specified overlays so door is out at cab box size, no perimeter reveals at all. So far so good.

Rotate wallcab, move it over so it just kisses the side of the base cab. Vector camera view.

OK, sez me. Now let's see if we can change the door type, materials, etc., on the paste-on side. No problemo.

Until!

We make our frameless basecabs with 23-3/4 depth boxes, and depending on door style for the fronts, want our finished ends to project forward of cab front by 5/16" to 5/8". That means that a finished end width always is over 24 inches, and when I exceed the 24 width, Chief wants to give me two doors!

How is this overridden?