Results 1 to 6 of 6
Thread: Auto Stairwell problem
-
10-12-2008, 06:58 PM #1Registered User Promoted
- Join Date
- Aug 2008
- Location
- Warner Robins, GA
- Posts
- 32
Auto Stairwell problem
Hello,
I have crept upon a problem that I can't figure out. I have a set of stairs on the first floor that were extended to the second floor without a problem. Now, when I select "Auto Stairwell" for those stairs, I get an info pop-up that says "Cannot find the floor above the stairs in which to place the stairwell." Is this something that someone has run into and has a solution? Thanks.
Scott
-
10-12-2008, 07:01 PM #2
Did you already make an open below room above?
-
10-13-2008, 06:31 AM #3Registered User Promoted
- Join Date
- Sep 2005
- Posts
- 16
I usually get this error when the room above is open check your walls to make sure they are all connected
-
10-13-2008, 06:40 AM #4
Is there a floor above or the Attic?
Attic = either make a new floor or use the platform hole to make the opening..........
Allen Colburn Jr.
Pascoag RI 02859
Residential Design Drafting/Framer
Drafter for:
http://www.artformhomeplans.com/
Chief Architect X4
-
10-14-2008, 12:59 PM #5Registered User Promoted
- Join Date
- Aug 2008
- Location
- Warner Robins, GA
- Posts
- 32
That was it. I had made some wall changes and the room designation was no longer "Open Below". Thanks.
-
10-14-2008, 02:30 PM #6
Glad I could help.